Alfano Lambda LSU Kit Alfano 7, A2502-PACK

LAMBDA Sensor – enables tuning lights mode.

The controller with the LSU 4.9 Lambda sensor is connected directly to the black port (BUS) of the Alfano 7 or to the Box12 connected to an ALFANO 7.

Please note that this new lambda sensor and controller cannot be used with an ALFANO 6, nor with a box 12 (A1160) connected to an ALFANO 6.

Description

“New in the ALFANO range

This LSU 4.9 wideband lambda sensor measures the air/fuel ratio at all times, at both low and high engine speeds (RPM).

Very useful for quickly finding the best performance from your engine.

Requires 12V DC power supply (battery).

The controller with the LSU 4.9 Lambda sensor is connected directly to the black port (BUS) of the Alfano 7 or to the Box12 connected to an ALFANO 7.

Please note that this new lambda sensor and controller cannot be used with an ALFANO 6, nor with a box 12 (A1160) connected to an ALFANO 6.

This pack includes :

A2503: LSU 4.9 Lambda sensor

A2504: The probe controller (electronic box)

A2505: One stainless steel threaded nut for mounting the probe, to be welded onto the exhaust pipe + one bolt (plug).

INSTALLATION

The temperature sensor (LAMBDA) must be positioned in the output of the engine exhaust gas,
at an approximate distance: 100-150mm (3.93/5.9inch)
1) Drill a hole with a diameter of 18mm (0.70inch).
2) Solder the nut provided
3) Fix the sensor with a 22mm spanner (do not tighten too hard)

WARNING: During installation, take care to remove the wire of this sensor from the other cables,
mainly of the type: RPM, high tension ignition system, in order to avoid mutual interference.